5
Before You Begin
Prepare the Required Hardware and Tools
3 Before You Begin
Before installing and setting up the Access Point, Ruckus Wireless recommends that you
first complete the following pre-installation tasks.
Prepare the Required Hardware and Tools
You must supply the following tools and equipment:
■ A notebook computer running on Windows XP/2000 and installed with one wireless
802.11b/g/n network card and one Ethernet card
■ A pair of long nose pliers
■ 6mm flathead screwdriver
■ 6mm Phillips screwdriver
■ 10mm ratchet wrench
■ Electric drill with 8mm drill bit (if mounting on a flat surface)
NOTE: At the beginning of each procedure, this guide lists the specific tools, accessories,
and equipment that you will need to complete the procedure.
To Next Page
Loading...
