To Next PageTo Next Page
Need help?Do you have a question about the Ruckus Wireless ZoneFlex 7352 and is the answer not in the manual?
General| Model | ZoneFlex 7352 |
|---|---|
| Power over Ethernet (PoE) | 802.3af |
| Frequency Bands | 2.4 GHz, 5 GHz |
| Ethernet Ports | 1 x 10/100/1000 Mbps |
| Antenna Type | Internal |
| Mounting Options | Wall, Ceiling |
| Weight | 1.5 lbs |
Essential safety precautions for installation and operation of Ruckus Wireless APs.
Explains text and notice conventions used throughout the user guide.
Introduces Ruckus Wireless APs, their features, and deployment modes.
Highlights physical features of various Ruckus Wireless AP models.
Details front and rear panel features of the ZoneFlex 7055 AP.
Describes front/rear panel elements for ZoneFlex 7321, 7341, 7343, 7352, 7363, 7372 APs.
Explains features of the ZoneFlex H500 AP, including panels and ports.
Details front panel LEDs and bottom panel connectors for the ZoneFlex R710 AP.
Pre-installation tasks including site survey and optimal mounting.
Step-by-step guide for initial AP configuration before network deployment.
Procedures to verify correct AP operation and network connectivity.
Instructions for physically placing and connecting the AP to the network.
Steps to connect the AP to a power source and the network environment.
Provides solutions for common installation issues and factory reset procedures.
Guide on initial AP configuration steps before accessing the web interface.
Explains the structure and elements of the Ruckus Wireless AP web interface.
Highlights differences in web interface menus for dual-band AP models.
Customize AP name, location, service provider login, and LED settings.
Set up AP's network connection, VLANs, and IP addressing.
Configure common and individual WLAN settings for APs.
Define behavior of AP's Ethernet ports, including type and VLAN settings.
Set up Hotspot service with redirect URLs and RADIUS server authentication.
Check current device settings, internet, and local subnet configurations.
Instructions to change the default administrator username and password.
Configure HTTP, Telnet, SSH, and FlexMaster management access.
Guide on performing manual or scheduled firmware upgrades for the AP.
Procedures for rebooting the AP or resetting it to factory defaults.
Tools for checking network connections using ping and traceroute.
Command syntax and options for configuring LACP on R710 APs.
