Introducing the Ruckus Wireless AP
Getting to Know the AP Features
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 70
ZoneFlex R710 AP
The R710 is a high-capacity, high-performance, four-stream, 802.11ac Wave 2,
dual-band AP with adaptive antenna technology for carriers and enterprises.
• The R710 has a USB port on its bottom panel. The USB port is intended for low-
power devices such as BLE (Bluetooth low energy) beacons. The maximum
power that the USB port can supply is 0.5W. Refer to Appendix A: AP Support
for Bluetooth Low Energy Devices for more information.
• The R710 can use the link aggregation control protocol (LACP) to control the
bonding of two 1Gbps physical Ethernet ports together to form a single logical
channel. Refer to Appendix B: Configuring Link Aggregation (LACP) for AP
Backhaul for instructions on bonding the two Ethernet ports using LACP.
NOTE The 100.x AP base images support standalone mode and FlexMaster (FM)
WLAN manager operation. The SmartZone software-compatible images only
support SCG, SZ and vSZ controllers. The ZD-compatible images only support ZD
controllers.
The R710 AP requires a minimum of AP base image 100.2.0 and later to operate,
or SmartZone software 3.1.1 and later, or ZD 9.12 and later to operate.
NOTE The R710 is not supported by the ZoneDirector 1100.
The R710 includes five LEDs on its front panel, and buttons and connectors on its
bottom panel.
To Next Page
Loading...
