Installing the AP
Step 1: Preconfiguring the AP
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 85
Figure 38. The Ruckus Wireless AP login page
5 In User name, type super.
6 In Password, type sp-admin.
7 Click Login. The Web interface appears, displaying the Status > Device page.
8 Continue to “5. Configuring the Wireless Settings” below.
5. Configuring the Wireless Settings
To complete this step, configure the settings on the Common tab and at least one
Wireless # (WLAN Number) tab. These are the essential wireless settings that
enable wireless devices on the network to associate with the AP.
For your reference, the default wireless settings for the WLANs are listed in Table 41.
Table 41. Default WLAN wireless settings
Setting Default Value
SSID (network name) Wireless 1 to Wireless 8 (2.4 GHz Radio)
Wireless 9 to Wireless 16 (5 GHz Radio - only
available on dual radio APs)
Encryption (security) Disabled on all WLANs
Default management IP address
192.168.0.1
To Next Page
Loading...
