Navigating the Web Interface
Before You Begin: Preconfiguring the AP
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 109
Configuring the AP for Management by an SCG, SZ or
vSZ Controller
When your Ruckus Wireless network is managed by an SCG, SZ or vSZ controller,
you can manage APs using the controller rather than individually logging into each
AP’s Web interface.
If SCG, SZ or vSZ controllers are installed on the network, then follow the SCG, SZ
or vSZ instructions to configure the controller, and then connect the AP to your
network. The AP finds the SCG, SZ or vSZ, and then downloads the SCG-, SZ- or
vSZ-compatible AP image from the SCG, SZ or vSZ controller.
NOTE The AP must have some way of obtaining an IP address (IPv4 DHCP or IPv6
Auto Configuration).
Configuring the AP for Management by ZD
When your Ruckus Wireless network is managed by a ZD controller, you can
manage APs using the controller rather than individually logging into each AP’s Web
interface.
If ZoneDirector is installed on the network, then follow the instructions in the
ZoneDirector User Guide and connect the AP to your network. The AP finds the
ZD, and then downloads the ZD-compatible AP image from the ZD controller.
NOTE The AP must have some way of obtaining an IP address (IPv4 DHCP or IPv6
Auto Configuration).
To Next Page
Loading...
