Installing the AP
Step 2: Verifying AP Operation
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 91
Step 2: Verifying AP Operation
Before deploying the AP in your environment, Ruckus Wireless strongly recom-
mends that you verify that the AP is operating correctly. To do this, connect the AP
to your live network temporarily and make sure that the network connection works
and that wireless clients are able to associate with the AP and connect to your
network and the Internet.
NOTE The network and power connections that you make in this step are
temporary.
Continue with the following:
• Connecting the AP to the Network
• Associating a Wireless Client with the AP
• Checking the LEDs
• Checking the TR069 Status (FlexMaster Management Only)
• Disconnecting the AP from the Network
Connecting the AP to the Network
1 Connect the Ethernet cable from a LAN (RJ-45) port on the AP to your network’s
router or switch.
2 Reconnect the AP to a power source.
You have completed connecting the AP to your live network. Perform the tasks
described in the following sections to verify that the AP is operating normally.
Associating a Wireless Client with the AP
1 On the administrative computer, verify that the wireless interface is enabled. On
Windows XP, click All Programs > Connect To > Wireless Network
Connection to enable the wireless interface. (Other operating systems are
similar).
2 Connect your admin computer to the wireless network:
• Windows XP: In the system tray, right-click the (Wireless Network Connec-
tion) icon, and then click View Available Wireless Networks.
• Windows 7: Left click the icon.
To Next Page
Loading...
