Installing the AP
Step 1: Preconfiguring the AP
Ruckus Wireless Indoor AP 100.2.0 User Guide, 800-70892-001 Rev A 90
6. Disconnecting the AP from the Administrative Computer
1 Disconnect the AP from the power source.
2 Verify that the power LED on the AP is off.
3 Disconnect the Ethernet cable from the administrative computer’s Ethernet port.
7. Restoring the Administrative Computer’s Network
Settings (Optional)
1 On your Admin computer, open the Network Connections (or Network and
Dial-up Connections) control panel according to how the Start menu is set up:
• On Windows 7, click Start > Control Panel > Network and Internet >
Network and Sharing Center > Change Adapter Settings.
• On Windows XP, click Start > Control Panel > Network Connections.
2 When the Network Connections window appears, right-click the icon for Local
Area Connection, and then click Properties.
3 When the Local Area Connection Properties dialog box appears, select Internet
Protocol (TCP/IP) (TCP/IPv4 in Windows 7) from the list, and then click
Properties. The TCP/IP Properties dialog box appears.
4 Restore the computer’s network settings by typing the original IP address
settings in the TCP/IP Properties dialog box.
5 On the TCP/IP Properties dialog box, click OK to close it.
6 Click OK again to close the Local Area Connection Properties dialog box.
You are now ready to connect the AP to your network.
To Next Page
Loading...
