RuggedCom RSG2488

RUGGEDCOM RSG2488
Installation Guide
Chapter 2
Installing the Device
Wiring Power Supply Terminal Blocks 9
CAUTION!
Electrical hazard — risk of damage to the device. Do not connect AC power cables to a DC power
supply terminal block. Damage to the power supply may occur.
Connectors for Power Modules
WARNING!
Electrocution hazard — risk of serious personal injury and/or damage to the device. Make sure the
supplied cover is always installed over the HI/HIP terminal block.
43
2
43
1
Figure 8: Power Supply Terminal Blocks
1. Insulated Terminal Block for HIP Power Modules 2. Screw-Type Terminal Block for HI Power Modules 3. Connectors for HI and HIP
Power Modules 4. Connectors for 24, 24P, 48, and 48P Power Modules
Wiring Examples
+
Figure 9: Single AC Power Supply Wiring
+
+
Figure 10: Dual AC Power Supply Wiring