Chapter 3
Modules
RUGGEDCOM RSG2488
Installation Guide
18 Removing Modules
Section 3.2.2
Removing Modules
Once a module is removed, all the features associated with the module are hidden or disabled in the operating
system.
To remove a module, do the following:
1. Make sure power to the device has been disconnected and wait approximately two minutes for any
remaining energy to dissipate.
2. If the device is installed in a rack, remove it from the rack.
3. Loosen the screws that secure the module to the chassis.
4. Pull the module from the chassis to disconnect it.
Figure 28: Removing a Module
1. Module 2. Chassis 3. Screw
5. Install a new module or a blank module (to prevent the ingress of dust and dirt). For more information, refer
to Section 3.2.1, “Installing Modules”.
6. If necessary, install the device in the rack.
7. Connect power to the device.
Section 3.3
Installing/Removing SFP Optical Ports
The RSG2488 can be ordered with SFP (Small Form-factor Pluggable) optics modules. The optical ports in these
modules can be safely inserted and removed while the chassis is powered and operating.
The following sections describe how to install and remove SFP optical ports:
• Section 3.3.1, “Installing an SFP Optical Port”
To Next Page
Loading...
