Hardware Installation and Reference Guide Preparing for Installation
19
(3) The distance between the square hole strip on the rack column and the outer side of the front cabinet door
is greater than 180 mm (7.09 in.) and the thickness of the front cabinet door is smaller than 25 mm (0.98 in.).
Therefore, the available space is greater than 155 mm (6.10 in.). The cabinet depth (the distance between
the front and rear doors) is greater than 1000 mm (39.37 in.).
(4) The slide rails (or trays) of the cabinet meets the requirements of the device and support its weight.
(5) A ground terminal is installed reliably on the cabinet to ensure that the device is fully grounded.
(6) The cabinet is well ventilated and the porosity of the front and rear panels is greater than 50%.
2.4 Tools
Table 2-4 Tools
Phillips screwdrivers, power cords, network cables, fastening bolts, diagonal pliers, and
binding straps
Antistatic gloves, wire stripper, crimping pliers, crystal connector crimping pliers, and wire
cutter
To Next Page
Loading...
Need help?
General
