Hardware Installation and Reference Guide Appendix
33
⚫ The power cords connecting moving parts such as door grounding wires should be reserved with some
access after being assembled to avoid suffering tension or stress. After the moving part is installed, the
remaining cable part should not touch heat sources, sharp corners, or sharp edges. If heat sources cannot
be avoided, high-temperature cables should be used. If heat sources cannot be avoided, high-temperature
cables should be used.
⚫ When screw threads are used to fasten cable terminals, the bolt or screw must be tightly fastened, and anti-
loosening measures should be taken, as shown in Figure 6-6.
Figure 6-6 Cable Fastening
Table 6-2 Cable Fastening Components
⚫ Hard power cords should be fastened in the terminal connection area to prevent stress on terminal connection
and cable.
⚫ Do not use self-tapping screws to fasten terminals.
⚫ power cords of the same type and in the same cabling direction should be bundled up into cable bunches,
with cables in cable bunches clean and straight.
⚫ Bundle up cables by using cable ties based on the following table.
To Next Page
Loading...
Need help?
General
