Web-based Configuration Guide L3 Management
95
Static routes are manually configured by the user. When a data packet matches a static route, the packet will
be forwarded according to the specified forwarding mode.
Caution
Static routes cannot automatically adapt to changes of the network topology. When the network topology
changes, you need to reconfigure the static routes.
Click Add. In the dialog box that appears, enter the destination address, subnet mask, outbound interface, and
next-hop IP address to create a static route.
Table 6-4 Description of Static Routes Configuration Parameters
Specify the destination network to which the data packet
is to be sent. The device matches the data packet based
on the destination address and subnet mask.
To Next Page
Loading...
Need help?
General