Ruijie RG-S5300-E Series - Page 30

Hardware Installation and Reference Guide Product Overview
26
Cooling
The RG-S5310-24GT4XS-P-E switch adopts a left-to-right and front-to-right airflow to ensure normal operation. Maintain a minimum
clearance of 100 mm (3.94 in.) around the device for air circulation.
Figure 1-28 Airflow Direction
LED
Function
Panel ID
Color
Status
System Status LED
Status
Off
System is not powered on.
Blinking Green (3
Hz)
System is being initialized. Continuous blinking indicates a
fault.
Blinking Green (10
Hz)
System is being located.
Solid Green
System is operating normally.
Solid Yellow
The temperature at the air intake and exhaust vents
exceeds the threshold.
Solid Red
1. The temperature at the air intake and exhaust vents
well exceeds the threshold.
2. The system is not functioning properly.
Power Supply Status LED
PWR1/PWR2
Off
The power supply module is not seated.
Solid Green
The power supply module is seated and providing power
to the switch.
Solid Yellow
The model of the power supply module is not supported
or cannot be identified.
Solid Red
The redundant power supply module is not functioning
properly or not connected with the AC power cord.
Management Port LED
MGMT
Off
No link is detected for this port.
Solid Green
The port has made a successful 1000 Mbps link.
Blinking Green
The port is sending and receiving traffic at 1000 Mbps.
Solid Yellow
The port has made a successful 10/100 Mbps link.
Blinking Yellow
The port is sending and receiving traffic at 10/100 Mbps.
LED Mode Indicator
LED Mode
Solid Green
Switching status
Solid Yellow
PoE status