F11GIM2 User Manual
6.5 Charging the Controller
Copyright ©2021 Ruko All Rights Reserved.
15
When the remote control is charging, the LED screen will indicate the battery level, when fully
charged, it will indicate "BAT 100 PCT" Controller is built-in 3.7V 1500mAh lithium polymer
battery. Use the original type-C cable to connect an AC power adapter (4.5V-5.5V, 2A-3A)
to charge. It takes apporximately 2hours to full charge the remote controller. The charing
time depends on what adapter are using, suggest to use charger with output currency 5V/3A.
Never overcharge.
Phone Adapter: 5V--3A
(Not Included)
USB Adapter
(5V/3.0A)
Charging Time: About 2 Hours
(Depending on Charging Adapter)
The Remote Control Is Charging Fully Charged With Remote Control
To Next Page
Loading...
