Place the drone in an open, flat area, remove the gimbal cover.
Power on the remote controller and the drone.
Wait until the remote controller and drone connectted, connect the app, complete the
calibration process.
Keep the drone camera facing forward, start the motors.
Gently push the throttle joystick up to take off.
Pull the throttle joysticks down to land the drone.
Stop the motors after landing.
Power off the drone remote controller, replace the gimbal cover.
This connect process take around 40seconds.
14 Flight
14.1 Takeoff/Landing Procedures
bottom bottom
3
2
1
Step 1: Turn on the controller
Power on the controller, lift up the antenna to receive
signal.
Step 2: Turn on the drone
Remove the gimbal cover gently, place the drone on a
level surface, power on the drone. All lights blinking red.
Drone and remote controller connects successfully, all
lights flashing white and blue then turn to flashing
white and pink.
F11GIM2 User Manual
Copyright ©2021 Ruko All Rights Reserved.30
To Next Page
Loading...
