The upper line of the display will always show the selected
drink, while the second line shows the sellable parameters
from time to time.
BEVERAGE SEQUENCE:
A 1000
This item allows the setting of the sequence with which the
products composing the drink shall be prepared and
dispensed (in this case A). Up to three products may be
inserted. To change the value, which varies between 0, 1 and
C, follow the procedure described in chapter "7.5 Changing
and saving parameters"
Important
In this function the digit 0 corresponds to no product, as a
consequence the digit combination corresponding to
"0300" or "0030" will always provide for the dispensing of
product 3
Depending on the sequence, it will be asked to set the
parameters relating to the products that shall be dispensed in
the drink.
Press the "UP" and "DOWN" keys to scroll the drink
composition.
BEVERAGE A
% SOLUB. 1: 160
It indicates the speed with which soluble powder and water
are dispensed in drink A.
Important
By setting the value on 10 the pump works at maximum
flow rate, while the soluble product is dispensed by
impulses at minimum flow rate.
By setting the value on 100 both the soluble product and
water are dispensed at maximum flow rate.
By setting 190 the pump works by impulses at minimum
flow rate, while the soluble product is dispensed at
maximum flow rate.
To change the dispensing speed follow the procedure
described in chapter "7,5 Changing and saving parameters",
Important
Soluble powder and hot water may be adjusted between
10 and 190, with 10-by-10 steps.
(Only D.A. 5P)
It defines the quantity of soluble product to be mixed with
water. The lower ine shows "SOLUBLE 1:045". 045
indicates that 45 units of soluble product will be used. To
modify the soluble product quantity follow the procedure de-
scribed in chapter "7.5 Changing and saving parameters".
Important
The quantity of soluble powder may be adjusted from 0 to
250 with 1-by-1 steps.
The product is not dispensed when the parameters are set
on "0000"
BEVERAGE A
If defines the quantity of coffee to be dispensed.
The lower line shows "COFFEE: 050".
050 means that 50 ground coffee units shall be dispensed.
To change the coffee quantity follow the procedure described
in chapter "7.5 Changing and saving parameters".
Important
The quantity of dispensable coffee may be adjusted from 0
to 500 with 2-by-2 steps.
The product is not dispensed when the parameter is set
on "00000"
Example of a drink with one soluble product and coffee.
It defines the quantity of water to be mixed with the soluble
powder or coffee.
When "WATER 1:045" appears on the lower line, this
means that water will be mixed with the soluble product or
with coffee. 045 means that 45 water units will be dispensed
in the soluble product or in coffee.
To modify the water quantity follow the procedure described
in chapter "7.5 Changing and saving parameters".
Important
The quantity of hot water may be adjusted from 0 to 250
with 1-by-1 steps.
The product is not dispensed when the parameters are set
on “0000"
18
BEVERAGE C
The letter "C", displayed in the first line indicates the drink
corresponding to the C key (upper third in the keypad - ref. 3,
fig. 1 7).
The four digits indicate the products (coffee and/or soluble
product) shall be used to compose the drink.
In this example drink dispensing, selectable with the C key,
shall be obtained by mixing water, coffee and soluble
product.
N.B.: the same drink may be obtained with the same
products, set in different sequence (e.g. C001, or 0C01, etc.).
Pressing the "DOWN" key moves the display to the next item.
To Next Page
Loading...
