English
Important
Before using the vending machine if' necessary to
carefully read this publication and acquire a good general
knowledge of the vending machine.
After a period of inactivity of the vending machine it is
advisable to read chapter "8.6 First start of the Vending
machine" before re-using it.
8.1 Machine statuses
Depending on electric mains supply, the vending machine
may be in one of the following statuses:
Off and electrically isolated
- Main switch (ref. 25, fig. 1) in the "0" position.
- Only the programmed data maintenance memory is active.
On
- Main switch (ref. 25, fig. 1) in the "I" position.
- All the functions are active and the display (ref. 1, fig, 1) is
on.
Standby (vending machine off, but not electrically isolated]
- Main switch (ref. 25, fig. 1) in the "I" position.
- The "ON/OFF TIME" function is set on "YES".
The display and the programmed data maintenance
memory are active.
8.2 Manual start
This type of start up is required when the vending machine is
in the "Off and electrically isolated" status, (see 8.1 Machine
statuses). Follow the procedure described in "8.6 First start of
the vending machine", eventually leaving out the control of
the dispensed drink.
8.3 Programmed automatic start
This is possible when the vending machine is on "STANDBY"
and the "ON/OFF TIME" function is active and set. Vending
machine start up occurs at the programmed time.
22
8.4 Drink dispensing
• Choose a drink among the ones available and identify the
corresponding price.
• Insert coins (or tokens) in the special slot (ref. 4, fig. 1) until
the display (ref. 1, fig. 1) visualizes the required amount.
Warning
It's impossible to insert coins once the amount equaling the
maximum vending price has been reached.
• Extract a cup and place it in the dispensing slot (ref. 9, fig. 1).
The display indicates "SELECT BEVERAGE" (select drink).
Warning
If a button is pressed corresponding to a drink having a
higher price than the one inserted, it's necessary to insert
more coins and press the chosen button once again.
The display indicates for a moment "INSERT COIN"
(insert token)
• Press the button corresponding to the chosen drink.
8.5 First start
of the Vending machine
Once the drinks dispensed by the vending machine have been
determined (see "7 - Programming"), get the products to be
inserted in the containers (coffee, soluble products, etc.).
Important
It is indispensable to use only soluble products declared to
be "suitable for automatic vending".
Tank filling
Important
The lyophilized product must compulsorily be poured in its
container (ref. 6, fig. 1).
Do not put coffee beans in the soluble product container.
Soluble product container (only DA 5P)
Proceed in filling the lyophilized product container:
- Extract the container from its seat by slightly lifting it to make
its extraction easier.
8 - USE OF THE VENDING
MACHINE
To Next Page
Loading...
