Soluble powder container
- Extract the container form its seat by slightly lifting it to
make its extraction easier (fig. 32). The soluble powder
container doesn't require special maintenance.
Nevertheless, it should be cleaned at least on a monthly
basis, making sure that it's perfectly dried when filled. The
container may be separated from the front and back
bushings by rotating the latter clockwise, allowing back pin
and spring extraction. Clean everything with a dry cloth or
compressed air, then refit performing all operations in
reverse order, making sure that the sealing ring of the
back pin is perfectly intact.
Water tank
The water tank should be emptied and cleaned every time it
is filled.
Dispensing slot area
Unfit the dispensing slot by simply extracting it from its seat.
Separate it from the grill, the tray and the drip tray and wash
everything with lukewarm wafer (fig. 33).
Important
The manufacture disclaims all responsibilities for possible
malfunctioning caused by improper or scarce
maintenance.
9.3 Mix fan replacement
Remove the old fan, insert the new one in the special tang,
rest the wrench on the fan flanging and then press in the axial
direction until the wrench is in contact with the motor bearing
surface (fig. 34). For further specific instructions, refer to the
special maintenance manual.
10 - VENDING MACHINE
SCRAPPING
The disposal of the wastes coming from vending machine
scrapping should be performed while respecting the
environment, avoiding ground, water and air pollution.
In any case local existing laws ruling the matter shall be
complied with. Make the vending machine unserviceable by
disconnecting the plug from the outlet and cutting the electric
cable. Deliver the unserviceable vending machine to a
suitable disposal center. The information in this manual is
subject to changes without notice decided by the
manufacturer. The contents of this manual are confidential
and no part of it may be reproduced in any form or mean, be
it electronic or mechanic, for any use, without manufacturer's
permission. The manufacturer disclaims any liabilities for
inaccuracies arising out of printing or transcription errors.
11 • VARIATIONS
11.1 Model D.A. 3P/5P
(without clock module)
The vending machine model 3/5P without the clock module is
used in the same way, has the same intended use and
components of the more complete model.
The only difference is in the management of the fifth main
menu item (see "1 1.2 Programming structure" (3/5P model
without clock module)"); actually, in this model the fifth item
"FREE VEND... " manages two choice options "NEVER"
and "ALWAYS" (In the version with clock module this item is
integrated in "TIME MANAGEMENT").
28
English
To Next Page
Loading...
