Saeco IDEA RST User Manual

English
5
16
5.4 Connection to the Electric Network
The Maintenance Technician, who is in
charge of the appliance's installation, shall
make sure that:
• the power supply system complies with the safety instructions in
force;
• the voltage corresponds to that indicated on the appliance data plate.
In case of doubt, do not proceed with the
installation and ask qualified and authorised
personnel to accurately check the system.
Also make sure that the electrical system
the appliance is connected to has the
capacity to bear the max load required, as
indicated on the data plate.
Make sure that the power cord plug is
easily reachable after installation.
The electric socket or the all-pole switch
which the appliance is connected to must
be easily accessible for the user, so that the
user will easily disconnect the appliance
from the electric mains when necessary.
If damaged, the power cord must be
replaced by the Maintenance Technician
only.
• Insert the electric power cord into the proper hole (see chapter
“Unpacking and Positioning”).
• Connect the appliance to the mains by means of the power cord.
NOTE
In case of plants with a 400 V two-phase current, use the two phases
so as to supply the machine with a 230 V single-phase current. Ask
for the special installation kit (code 1034.R09) for the 230 V
single-phase connection.
- Power cord type H07RNF section 4x2.5 mm2
N Neutral – Blue
L1 Phase – Brown
L2 Phase – Black
T Ground – Yellow/green
- Connection of the two phase power supply plug 400 V 2 N~
CH Switzerland
CEI in compliance with CEI standards
Depending on the regulations in force in
the Country where the machine is being
used, the cable connecting to the power
supply has to be pre-set or equipped with
an all-pole switch (with a minimum contact
opening of 3 mm), or with a plug
complying with the same regulations.
The all-pole switch must be suitable for
machine input and be able to detect all
voltage polarities.
Check that the electrical cables of the
system are proportioned to machine input.

Saeco IDEA RST Specifications

General

Brand	Saeco
Model	IDEA RST
Category	Coffee Maker
Language	English