English
5
25
When the sensor has been connected, reinstall the
protection cover using the screw.
Reassemble the drip tray.
Following installation, enable the products dispensed upon
payment and set their price. Access the programming
mode to carry out this procedure.
The machine allows you to
select a price line (0, 1, 2)
whose associated value is
set by the payment system
through a dedicated
software.
5.5 Connection to the Electric
Network
This operation must only be
performed by specialised
technical personnel or by
the service provider.
The Maintenance Technician, who is in charge of the appliance's
installation, shall make sure that:
• the power supply system complies with the safety instructions in
force;
• the voltage corresponds to that indicated on the appliance data
plate.
In case of doubt, do not
proceed with the installation
and ask qualified and
authorised personnel to
accurately check the system.
Do not use adapters or
multi-sockets.
Make sure that the power
cord plug is easily reachable
after installation.
To Next Page
Loading...
