Saeco SUP040RB - Maintenance

English
10
93
If they do not match, proceed as described below:
Ensure that the lever is in contact with the brew group
base.
Make sure that the hook which locks the brew group is in
the correct position. firmly press the "PRESS" button to
check its position.
Insert the brew group into its seat again until it locks into
place WITHOUT pressing the "PRESS" button.
Insert the coffee grounds drawer and the drip tray. Close
the service door.
10.2.9 Brew Group Cleaning with
the "Coffee Oil Remover"
Besides weekly cleaning, we recommend performing a
cleaning cycle with "Coffee Oil Remover" after
approximately 500 cups of coffee or once a month.
This operation completes the maintenance process for the
brew group.
Both the "Coffee Oil Remover" system used to clean the
brew group and the "Maintenance Kit" may be purchased
at your local dealer or at authorised service centres.
The "Coffee Oil Remover"
system has no descaling
properties. For descaling,
use the Saeco descaling
solution and follow the
procedure described in the
"Descaling" chapter.
The wash cycle cannot be interrupted. Do not leave the
machine unattended during this operation.
Do not drink the solution
dispensed during this
procedure. The solution
must be disposed of.
Switch to programming mode as described in section
"Access to the Programming Menu".
Press the "Clean" button and select the "MACHINE
MENU" option; press the "Coffee" button to access the
menu.