CS-I User and Maintenance, R.2.8 ENG
Safco Systems Ltd-Via Isonzo 17/b-20090 Cesano Boscone-Milan-Italy
tel. +39 024504433 Fax +39 024504321 E-mail:info@safcosys.it Web site: www.safcosys.it
27 of 109
P. Min. Limit 1 (1-30%) (PK)
Current Limit 1 (1-Imax) (PK)
T.Weld 1 Max. 0.5 (0.5-99.0) (EK,AD)
T.Weld 1 Min. 0.5 (0.5-99.0) (EK,AD)
T.Weld 2 Max. 0.5 (0.5-99.0) (EK)
T.Weld 2 Min. 0.5 (0.5-99.0) (EK)
Resistance Value 0.00 (0.00-650.00) (IF VE = YES)
Res.Max Limit 1 (1-30%) (IF VE = YES)
Res.Min Limit 1 (1-30%) (IF VE = YES)
Meas.Elect.Close 0.1 (0.1-250.0mm)
Meas.Elect.Close Tol.+ 0.0 (+0.0-9.9mm)
Meas.Elect.Close Tol.- 0.0 (-0.0-9.9mm)
Meas. Current Cut 0.1 (0.1-250.0mm)
End Measure Elect. 0.1 (0.1-250.0mm)
End Measure Elect.Tol.+0.0 (+0.0-9.9mm)
End Measure Elect.Tol.-0.0 (-0.0-9.9mm)
Weld Press 0.0 (0.0-9.9bar)
Tol Press 0.0 (0.0-1.0bar)
Weld Force 0 (0-1000dN)
Tol. Force 0 (0-20dN)
EXIT (Press +)
where specified the () parameter is only available in the indicated
operating mode.
The Imaxs are related to the pair of electrodes selected in the
program, if the related parameter is disabled the pair is intended
“N°1”
If the parameter "VE input"is"NO":
The work mode can be set: D ‰, V ‰, IK
If the parameter "VE input" and Yes' "
The work mode can be set: D ‰, V ‰, IK, PK, EK, AD
To Next Page
Loading...