Safeline MX3+ - DTMF and System Outputs; Additional Configuration Features

16
MX3+ v1.06 EN
© 2018 SafeLine and all the SafeLine products and accessories are copyrighted by law.
Configuration
Activate with DTMF 8
(Output 1, Configuration code 1)
The output is activated at the following events:
- DTMF tone 8 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
Activate with DTMF 9
(Output 2, Configuration code 1)
The output is activated at the following events:
- DTMF tone 9 is received.
The output is deactivated at the following events:
- 3 seconds after activation.
System Failure
(Output 1 & 2, Configuration code 2)
The output is activated at the following events:
- Telephone line OK.
The output is deactivated at the following events:
- Telephone line missing.
Emergency Bell
(Output 1 & 2, Configuration code 3)
The output is activated at the following events:
- Emergency alarm button input active.
- The call is not yet connected.
The output is deactivated at the following events:
- Emergency alarm button input deactivated.
- The call is connected.
Silence Disconnect
The function will automatically disconnect a call
if no sound is received from the alarm operator
within a set time. Only works for voice calls, not
for P100/CPC/Q23.
The configuration is performed via SafeLine Pro
or with the configuration code *92*X#, where X
specifies the time:
0 = The function is off.
1 = 30 seconds.
2 = 60 seconds (default).
3 = 90 seconds.
Software controlled volume control
The speaker volume is adjusted via the keyboard
control. Key 2 raises and Key 8 lowers the volume
in 6 steps. The volume can also be adjusted using
the command *76*X# where X is the desired
volume position between 1 and 6. Default value
is 3.
The set volume mode are stored in the EEPROM
so that the unit remembers the set position.
External Mic/speaker part
When a call is activated by the emergency
alarm button on the external mic/speaker part,
the microphone on the external mic/speaker
part will be used and the internal microphone
disconnected.
The speaker sound will however be heard from
both speakers simultaneously.