18
3270360_GB
CONTROL PANEL
The illustration shows the equipment control panel, while the list indicates the description and functionality of
the individual commands.
CHILL
FREEZE
HARD
STANDBY/ON KEY
With the card on standby:
• hold the button down for 1 sec to switch the tab page on
With the card on stop and the cycle selected:
• press this key once to start the cycle
With the card set on cycle running:
• press the button once to stop the cycle
NOTE: If you hold this key pressed for 3 seconds, you can set the card to Off
from any mode.
CHILL
POSITIVE SOFT QUICK COOLING KEY
With the card on stop:
• press this key once to select a positive soft quick cooling cycle
FREEZE
NEGATIVE QUICK COOLING KEY
With the card on stop:
• press this key once to select a negative quick cooling cycle
HARD
HARD QUICK COOLING KEY
With selected blast chill cycle
• press the button once to select the positive/negative/Hard chilling cycle
DEFROST KEY
With the card on stop:
• hold the button down for 4 seconds to run a defrosting cycle (if necessary)
UP AND DOWN KEYS
Use these keys to increase or decrease values
With the card on stop:
• hold the button down for 1 sec to access the probe display menu
To Next Page
Loading...
Need help?
General
