Sailor RT5022 Workshop Manual

Functional unit workshop service VHF 5000 System
3-16
3.2.11 Removing/installing the BB module from the VHF transceiver unit.
Use the following procedures & illustrations to remove/install the Base Band module. The sequence of the
procedures applicable to the removal and the installation respectively is numbered 1 and 2 and should be carried
out in this sequence.
(HSC-Flow)
Handset
connector
(MKDC-
flow) Radio
front conn.
(MPC-Flow)
module
power
tranceiver
control
(TIAF-flow)
transceiver
(Replace)
replace
baseband
(TIC-flow)
audio
(SW-Flow)
Software
flow
(OCGP-Flow)
option
connect GPS
(OCVDR-
flow)
option VDR
option conn.
relay
(SPD-flow)
SPARC-II
(OCR-flow)
data
40462
(HSC-Flow)
Handset
connector
(MKDC-
flow) Radio
front conn.
(MPC-Flow)
module
power
tranceiver
control
(TIAF-flow)
transceiver
(Replace)
replace
baseband
(TIC-flow)
audio
(SW-Flow)
Software
flow
(OCGP-Flow)
option
connect GPS
(OCVDR-
flow)
option VDR
option conn.
relay
(SPD-flow)
SPARC-II
(OCR-flow)
data
Fig. 3 Base Band module replacement. (See section 3.2.15 for details on fault identification)
The Base Band module is identified for replacements from several flows.
1007

Sailor RT5022 Specifications

General

Brand	Sailor
Model	RT5022
Category	Transceiver
Language	English