13
Detail
The active scanning window is active in the graphics display for 30 seconds (or pressing
OK). Then it turns off. After this window has been turned off, scanning can be turned off
using the following:
• Lifting handset off hook
• Pushing ´16´ - Channel 16 is used for working channel
• Pushing any numeric key – Normal channel entry
• Pushing DISTRESS – Initiates DSC distress
If scanning is terminated while no active signal was found, the VHF will receive on the
working channel (as it was before scanning was initiated).
If scanning is terminated (handset hook-off) while an active signal is received, the VHF will
operate on that channel after termination.
3.9 Creating Scan Tables
The scanning tables are user configurable. Creating or editing a scanning table organizing a
subset of channels (e.g. Table A) for scanning is done by selecting the Scanning Table A
menu (3.5.1).
Private channels (non-numeric identifiers – P, F or L) can be part of a channel table. The
number of channels in a scan table is limited to 10.
Scanning tables are stored during the power-down sequence.
0505
To Next Page
Loading...
Need help?
General
