16
Detail
The alphanumeric keypad can be used for quick search for items (using wheel mode).
Selecting a contact will show
data for that contact. Example:
When OK is pressed the appropriate call generator
will be initialized, based on the data.
If a PSTN number is present for the contact the PSTN call flow is initiated:
• If a coast station MMSI number is also available for that contact (as in the example
figure above) the operator will be lead to the transmit verification window for the
PSTN call.
• If no coast station MMSI number is present the operator will be lead to the window
where the coast station MMSI can be entered.
If only an MMSI number is present for the contact a station or group call is initiated:
• If the MMSI number is a group number the group call flow is entered from the window
where a channel is selected.
• If a ship station number MMSI is available the station call flow is entered from the
window where a channel is selected.
• If the MMSI number is a coast station the operator will be lead to the transmit
verification window for a station call.
Once entered the selected call sequence the maneuvering in Contacts is terminated and any
press on OK/
%
Menu will go forth and back in the call flow.
4.5.2 Show Contact
It is possible to search for a contact’s information without changing or initiate anything, via
the menu item 2.2.
4.5.3 Adding a New Contact
If you want to add a new contact to your list, go into menu item 2.3. The following empty
contact window will apply:
To Next Page
Loading...
Need help?
General
