8000m Series
- 125 -
delay time
Setting Options 0~200ms
Response delay time: It refers to the time span between the time VFD finishes
receiving data and the time VFD sends response data. If the response delay time
setting is shorter the system processing time, the delay is determined by the system
processing time. If the response delay time setting is longer than the system
processing time, then after the system processing is finished, it will wait to send
data to upper monitor until timing of the response delay time is over.
FC.04
Communication timeout
fault setting
Factory Setting 0.0s
Setting Options 0.0 (disabled), 0.1~100.0s
When this parameter is set as 0.0, it is disabled.
When this parameter is set as a valid none-zero value, if time span between the
current communicating and last communicating exceeds the setting time of FC.04,
system will handle the fault according to the setting of FC.05.
Normally, it is set as disabled. It is often set for monitoring communication in case
of application where continued communication is required.
FC.05
Method of disposing
communication timeout
fault
Factory
Setting
1
Setting Options
0 Alarm and coast to stop
1 No alarm and continue to run
2
No alarm but stop according to
F1.05 (only when F0.01= 2)
3
No alarm but stop according
to F1.05
This parameter is the selection for handling the fault of communication timeout
between upper monitor and VFD.
To Next Page
Loading...
Need help?
General
