Suntrio Plus Series
36
button to confirm the selection.
Note: The configuration of the country of usage must be set before inverter
starts to run for its first time; otherwise, the inverter will not operate correctly.
If users cannot locate the corresponding country, please abort the setting
and contact the after sales for confirmation.
6.2.2 State
If the country has been set the LCD shows the machine type when the
inverter is started up, then it automatically displays the inverter operation
status: Initialization, Normal, Wait, Fault or Update.
Initialization of the system
The inverter in normal (function) operation
The inverter in stand-by state
A fault occurs during operation
The state of updating firmware
Turn on the AC switch, the LCD begins to count seconds backwards, after
this, the inverter begins to connect the grid.
To Next Page
Loading...
