Section 7
Unload station tray needs replacement
Print head clean in progress
Ink cartridge needs replacement
Flash power supply over heated
Flash light reached lifetime
Manual Cleaning print head demanded
Perform print head cleaning procedure
The magazine is mechanically blocked
Remove the cause of the blockage
Faulty ejection of a slide or slide. Magazine is
blocked
The transfer of the slide from the loader chute to
the print carriage failed. Horizontal motor is
incorrectly positioned or mechanically blocked
Slide is stuck in the delivery chute
The horizontal drive is mechanically blocked
The vertical drive is mechanically blocked
The rotational motion is mechanically blocked
Faulty clamping of a slide. A slide left the
delivery chute but did not reach the print sledge
Remove the slide from the print sledge
The slide did not leave the print sledge or was
still located in the clamp during an initialization
Remove the slide from the print sledge
The ink print head is too hot. Ambient
temperature too high or electronics defective
Switch the instrument to the off position and let
cool. The instrument will remain disabled until
the print head cools to a regular temperature.
Check the ambient temperature is within
normal ranges
No or incorrect voltage at ink print head
Contact your technical support representative
Flash standby state not reached within the
prescribed time. Charging electronics defective.
Contact your technical support representative
Flash does not occur at all or is too short. Curing
lamp dirty or defective.
Check whether flash takes place-to do so,
observe the stray light coming from under the
cover. Never open the cover to check whether
the flash takes place!
No flash, install a new curing lamp
The temperature in the drying station is not
within the permissible temperature range
To Next Page
Loading...
General