Sakura Tissue-Tek Glas g2 User Manual

Section 4
Revised 3/30/2010 4.19
3. Press the ENTER key on the numeric keypad to
confirm the coverslipping program, and confirm that
the program number has been changed (Figure 4-
EE). Set (save) a coverslipping program for each
staining program. When setting a coverslipping
program, make sure the applicable program is already
programmed on the coverslipper side.
Figure 4-EE
4. Open the Prisma loading station access door, place
baskets in the specified loading station, and close the
door (Figure 4-FF).
Figure 4-FF
5. After confirming the staining program and the loading
station where the baskets have been placed, press
the START key to start the process (Figures 4-GG &
4-HH).
Figure 4-GG
Figure 4-HH
WARNING: MAKE SURE THE SLIDES ARE EVENLY
STORED IN THE BASKET. IF THE SLIDES ARE
STORED UNEVENLY, THE BASKET MOVEMENT IS
AFFECTED DURING THE STAINING OPERATION.
TAKE SPECIAL CARE WHEN THERE ARE ONLY A
SMALL NUMBER OF SLIDES. STORE THEM
CAREFULLY TO PREVENT THE BASKET FROM
TILTING.

Sakura Tissue-Tek Glas g2 Specifications

General

Brand	Sakura
Model	Tissue-Tek Glas g2
Category	Laboratory Equipment
Language	English