SAMES KREMLIN FPro G - Apply a Product on a Surface; Short Stop of the Gun; Prolonged Shutdown of the Gun

36
7.1 Apply a product on a surface
- Select the right fitting for your installation
- Connect the air hose.
- Check the proper operation of the gun without any product
and make a pre-setting of the supply pressure.
- Put the gun on its support .
- Fill the cup using a suitable filter.
- Put on the anti-drip membrane and close the cup.
- Perform spray tests on a test surface.
- Adjust the setting parameters to optimize spraying.
 Air pressure and flow rate.
 Fluid flow rate (needle stroke, nozzle size or pressure in the
cup (in case of GSP version only)
 Spray width
- Apply the product on the work piece.
7.2 Short stop of the gun
- put the gun on its adapted support
7.3 Prolonged shutdown of the gun
- Turn off general air
- Disconnect the gun
- Empty the cup.
- Cleaning the gun
- Put the gun away.
Original equipment
Connection ¼ NPS
Option Connection ¼ BSP
(included in the accessories box)