Samson 3730-3 - Page 42

42 EB 8384-3 EN
Mounting and start-up
If a pin position other than position 35 with
the standard M lever is required or an L or
XL lever size is required, proceed as follows
(seeFig.5):
1. Fasten the follower pin (2) in the as-
signed lever hole (pin position as speci-
edinthetraveltablesonpageSeite
26). Only use the longer follower pin
included in the mounting kit.
2. Place the lever (1) on the shaft of the po-
sitioner and fasten it tight using the disk
spring (1.2) and nut (1.1).