Samson 3730-3 - Page 6

To Next Page

To Previous Page

6 EB 8384-3 EN

The functions of the EXPERTplus Valve Diagnostics are described in the Operating

Instructions uEB8389. EB8389 is included on the enclosed CD-ROM and is available

on our website.

Note

Main Page

Table of Contents3
Safety Instructions and Measures7
Notes on Possible Severe Personal Injury11
Notes on Possible Personal Injury11
Notes on Possible Property Damage12
Markings on the Device13
Nameplate13
Article Code14
Firmware Versions15
Design and Principle of Operation17
Mounting Versions18
Additional Equipment18
Communication20
Configuration Using the TROVIS-VIEW Software20
Device Overview and Operating Controls20
Accessories21
Travel Tables26
Technical Data27
Dimensions in MM33
Fixing Levels According to VDI/VDE 3845 (September 2010)37
Measures for Preparation39
Unpacking39
Transporting39
Storage39
Mounting and Start-Up41
Mounting Position41
Lever and Pin Position41
Direct Attachment44
Type 3277-5 Actuator44
Type 3277 Actuator46
Attachment According to IEC 60534-648
Attachment According to VDI/VDE 3847-150
Attachment According to VDI/VDE 3847-254
Version for Single-Acting Actuator56
Version for Double-Acting Actuator58
Attachment to Type 3510 Micro-Flow Valve62
Attachment to Rotary Actuators62
Heavy-Duty Version64
Reversing Amplifier for Double-Acting Actuators68
Reversing Amplifier (1079-1118 or 1079-1119)68
Attachment of External Position Sensor70
Mounting the Position Sensor with Direct Attachment71
Mounting the Position Sensor with Attachment According to IEC 60534-673
Mounting the Position Sensor to Type 3510 Micro-Flow Valve74
Mounting on Rotary Actuators75
Mounting the Leakage Sensor76
Retrofitting an Inductive Limit Switch77
Attaching Positioners with Stainless Steel Housings78
Air Purging Function for Single-Acting Actuators78
Pneumatic Connections81
Connecting the Supply Air81
Signal Pressure Gauges82
Supply Pressure82
Signal Pressure (Output)83
Electrical Connections83
Connecting the Electrical Power85
Switching Amplifier According to en 60947-5-686
Establishing Communication86
Operation89
Serial Interface91
HART ® Communication92
Dynamic HART ® Variables92
Operating the Positioner95
Determining the Fail-Safe Position96
Adjusting the Volume Restriction Q96
Adapting the Display Direction97
Limiting the Signal Pressure98
Checking the Operating Range of the Positioner98
Initialize the Positioner100
MAX - Initialization Based on Maximum Range102
NOM - Initialization Based on Nominal Range103
MAN - Initialization Based on a Manually Selected Range105
Sub - Substitute Calibration106
Zero Calibration111
Adjusting Inductive Limit Switch112
Reset to Default Settings114
Enabling and Selecting Parameters115
Operating Modes116
Automatic and Manual Modes116
Fail-Safe Position (SAFE)117
Servicing119
Firmware Update119
Preparation for Return Shipment120
Malfunctions121
Confirming Error Messages122
Emergency Action122
Decommissioning and Removal123
Decommissioning123
Removing the Positioner123
Disposal123
Appendix125
After-Sales Service125
Certificates125
Code List126
Error Codes136
Selecting the Characteristic144
Certificates146

Samson 3730-3 - Page 6

Table of Contents

Other manuals for Samson 3730-3

Related product manuals