EB 8359-2 EN 37
Decommissioning and removal
9 Decommissioning and
removal
The process is disturbed by interrupting
closed-loop control.
Do not mount the positioner while the pro-
cess is running and only after isolating the
plant by closing the shut-off valves.
9.1 Decommissioning
To decommission the positioner before re-
moving it, proceed as follows:
1. Disconnect and lock the air supply and
signal pressure.
2. Open the positioner cover and discon-
nect the wires for the control signal.
9.2 Removing the positioner
1. Disconnect the wires for the control sig-
nal from the positioner.
2. Disconnect the lines for air supply and
signal pressure.
3. To remove the positioner, loosen the fas-
tening screws on the positioner.
9.3 Disposal
We are registered with the
German national register for
waste electric equipment (stiftung
ear) as a producer of electrical
and electronic equipment,
WEEE reg. no.: DE 62194439
Î Observe local, national and internation-
al refuse regulations.
Î Do not dispose of components, lubricants
and hazardous substances together with
your other household waste.
On request, we can appoint a service pro-
vider to dismantle and recycle the product.
NOTICE
!
Tip
To Next Page
Loading...
