46 Section 2B. Your Device’s Settings
Changing the Display Time-Out
Select the length of time the display stays on.
1. From standby mode, press Start > Settings > Power
Management > Display time out.
䡲 During standby, the device goes into sleep mode
after a specified period of time to conserve power.
Choose
Never, 10 seconds, 15 seconds, 30 seconds,
1 minute, 2 minutes, 5 minutes, or 10 minutes.
2. Press the navigation key left or right to select a new
time-out setting and press
Done (left softkey).
Changing the Brightness
Adjust your screen’s brightness to suit your
surroundings.
1. From standby mode, press Start > Settings > Power
Management > Display brightness.
䡲 Adjust the brightness level for the display.
Choose Level 1 - Level 5.
2. Press the navigation key left or right to select a new
level setting and press
Done (left softkey).
Changing the Keypad Backlight Time-Out
Select the length of time the keypad backlight stays on
when you do not use the keys.
1. From standby mode, press Start > Settings > Power
Management > Keypad backlight time out.
䡲 Choose 1 second, 2 seconds, 3 seconds, 4 seconds,
5 seconds, or 10 seconds.
2. Press the navigation key left or right to select a new
time-out setting and press
Done (left softkey).
Restricting the Keypad Backlight Time-Out
By default, the keypad backlight time-out is enabled all
the time. With this setting you can restrict the time of
day that the keypad backlight time-out will be enabled.
For example, if you were planning a day at the beach
(when you would not need the keypad backlight), you
could disable the backlight time-out for that period.
1. From standby mode, press Start > Settings > Power
Management > Keypad backlight on.
I325.book Page 46 Tuesday, December 11, 2007 11:23 AM
To Next Page
Loading...
