Troubleshooting
Samsung Electronics 4-63
IPM breakdown diagnostics (FAN PCB)
1. Preparations before checking
1) Power Off
2) IPM failure, discharge mode may not work properly. Therefore, wait more than 15 minutes after the Power Off.
3) Remove all of the Fan PCB connectors. ((FAN motor connector included.)
4) Prepar e the digital multi test er.
2. Inspection Method
1) Refer to Figure1 and Table1, respectively the resistance value and diode voltage value measure .
2) According to the criterion in Table 1 to determine whether the failure of IPM.
Division
Measured Point
Criterion Remark
+-
Measure
the resistance values
40 U
More than 500 Ꮒ
Measurement error can occur for reasons such as the initial
measurement condenser discharge .
Measured over at least three times.
40 V
40 W
U34
V34
W 34
Measure the diode
voltage values
U 40
0.3~0.7V
V 40
W40
34 U
34 V
34 W
< Table 1 >
)$1 3&%
< Figure 1 >
Fan PCB
To Next Page
Loading...
