Samsung AR5000 - GoodSleep Mode; Temperature and Fan Speed in GoodSleep Mode

mode
For a comfortable sleep, the air conditioner will operate it Fall asleep  Sound sleep  Wake up from mode.
• SetOtimerin mode over 5 hours. You fell disturbed sleep if the is set too short or long
because the default is set to 8-hour-operation.
• Ifthe mode is set less than 4 hours, the operation will stop at the same time.
If the mode is set over 5 hours, it will run as Wake up stage from the last one hour before it stops.
• Recommendedsettemperatureisbetween25˚C~27˚Cforcoolingand21˚C~23˚Cforheating( ARHP) .
Temperature and fan speed change in mode
• Fallasleep:Easesyouintosleepbydroppingthetemperature.
• Soundsleep:Relaxesyourbodyandraisesyourtemperatureslightly.
• Wakeupfrom mode:Allowsyoutowakeupfromcomfortableintermittentairanditmakesyoufeelrefreshed.
When the air conditioner is on and in cool/heat ( ARHP) mode
Press the Cancel button once again.Cancel
You can set the desired temperature by 1˚C in the range of 16˚C~30˚C.
Fan speed will be adjusted automatically according to the
mode.
However, I f you select mode while heating operation is on,
you can adjust fan speed ( ARHP) .
When the mode is on.
InCoolmode:Airowdirectionwillbeadjustedautomatically.
InHeatmode:Adjustingairowdirectionisavailable( ARHP) .
1. Press the button on the remote controller.
 
indicator appears and O timer indicator starts blinking on the remote
controller display.
2. Press the button to set the time.
 
You can set the time in half hourly unit from 30 minutes ~ 3 hours and hour unit from
3 hours ~ 12 hours.
 
Operating hour can be set from minimum 30 minutes to maximum 12 hours.
 
Default operation hour is set to 8 hours.
3. Press the Set button to activate it.
 
O timer indicator stops blinking and reserved time will be displayed for 3 seconds.
Then the air conditioner operates in good’sleep mode.
 
If you don’t press Set button within 10 seconds after pressing the or
Time Up or Time Down button, the air conditioner will return to previous status.
Check O timer indicator on the remote controller display and indicator on the
indoor unit.
English-18
A3050 CB&XL&CH_IB&IM_DB68-04138A_HP&CO_EN.indd 18 2013-12-28 14:43:37