134
Troubleshooting for Anynet+
Problem Possible Solution
Anynet+ does not work.
•
Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.
•
Check if the Anynet+ device power cord is properly connected.
•
Check the Anynet+ device’s Video/Audio/HDMI cable connections.
•
Check whether Anynet+ (HDMI-CEC) is set to On in the System menu.
•
Check whether the remote control is Anynet+ compatible.
•
Anynet+ doesn’t work in certain situations. (initial setup)
•
If you have removed and then reconnected the HDMI cable, please make sure to search devices again or turn your product
off and on again.
•
Check if the Anynet+ function of the Anynet device is set on.
I want to start Anynet+.
•
Check if the Anynet+ device is properly connected to the product and check if the Anynet+ (HDMI-CEC) is set to On in the
System menu.
•
Press the TOOLS button to display the Anynet+ menu and select a menu you want.
I want to exit Anynet+.
•
Select View PC in the Anynet+ menu.
•
If using the remote control, press SOURCE on the remote control and select a device that is not an Anynet+ device.
•
If using touchscreen control mode, touch and hold on the screen when the product is turned on to display the
administrator menu. Select Source
from the administrator menu.
The message “Disconnecting
Anynet+ device ...” appears on
the screen.
•
You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.
•
Use the remote control after the product has completed Anynet+ configuration or has finished switching to Anynet+.
The Anynet+ device does not play.
•
You cannot use the play function when initial setup is in progress.
To Next Page
Loading...
Need help?
General
