42
Calibration
―
Instructions below are for Windows 8. The same method applies to both Windows 7 and Windows 8.
―
After changing the Picture Size from the OSD menu, you may need to calibrate the picture settings again.
―
In the occurrence of an error during calibration, go to Tablet PC Settings
the Display tab. Tap Reset, and calibrate again.
1
In the Display tab, select Setup under Configure.
2
Tap the page displayed on the product with your finger.
―
In dual monitor mode: If the following page does not appear on the product, press the Enter key to
display the page.
Touch this screen to identity it as the touchscreen.
If this is not the Tablet PC screen, press Enter to move to the next screen. To close the tool, press Esc.
To Next Page
Loading...
Need help?
General
