Samsung DVM S ECO AM XMDG Series - Preparations for Air Conditioner Installation

6
AA
Preparations for Installation
Outdoor unit classication
Appearance
DVM S ECO
AM080/090FXMDG
AM080MXMDG
Safety precautions
Changes in DVM S ECO (inverter) compare to conventional models that has to noted when installing

For optimal distribution of the refrigerant, you must use Y-joint as branch joint for connecting outdoor units. (To not use
T-joint)

You cannot operate normally if you do not complete the trial operation through outdoor unit key mode. You must use
KEY MODE to run trial operation.

DVM S ECO air conditioner uses R-410A refrigerant.

Check the compatibility of other products such as indoor unit, EEV kits etc. which will be connected to DVM S ECO.
Packaging material disposition
• Safely store or dispose the packaging materials.
- Sharp metals such as nails or wooden material packaging that may break into pieces become a cause for
personal injury.
- Make sure to store or dispose the vinyl type packaging material to keep it out of reach of children. Children
may put them over their face, which is very dangerous since it may lead them to suffocation.
Caution
Accessories

You must keep following accessories until the installation is nished.

Hand over the installation manual to the customer after nishing the installation.
Installation Manual(1) Cap Drain(3) Drain Plug(1) Rubber Leg(4)