34
4. Troubleshooting
E-83
* Disconnect power.
* Get rid of connector (TE400,CN201)
on Sub PCB, Main PCB.
* Check whether harness connected
normally into TE400,CN201 on Sub PCB,
Main PCB.
* Check whether between connector
(TE400,CN201) pin and pin on Sub PCB,
Main PCB have a short circuit.
Ok
Ok
Ok
No
No
No
* With replacing Sub PCB, and make set work.
* Repair damaged harness or replace.
END
END
END
* Replace Sub PCB, Main PCB.
END
* Repair the area of circuit having short
Between connector(TE400,CN201) pins
on Sub PCB, Main PCB.
* Repair after confirming whether pattern
is Between micom and connector have
a short circuit or get damaged.
Main PCB
CN201
Sub PCB
TE400
4-1 Failure Display Codes
To Next Page
Loading...
