Names are written using the keypad. Each press of a key will select a char-
acter. Pressing the dial pad key moves the cursor to the next position. For
example, if the directory name is “SAM SMITH,” press the number “7” three
times to get the letter “S.” Press the number “2” once to get the letter “A.”
Continue selecting characters from the table below to complete your mes-
sage. Press the “A” key to change the letter from upper case to lower case.
NOTE: When the character you want appears on the same dial pad key as
does the previous character, press the UP key to move the cursor to the
right.
DS
24D KEYSETS and iDCS KEYSETS
COUNT 1 2 3 4 5
DIAL 0 < > . ) 0
DIAL 1 space ? , ! 1
DIAL 2 A B C @ 2
DIAL 3 D E F # 3
DIAL 4 G H I $ 4
DIAL 5 J K L % 5
DIAL 6 M N O ^ 6
DIAL 7 P Q R S 7
DIAL 8 T U V
4
8
DIAL 9 W X Y Z 9
DIAL
4
: = [ ]
4
The # key can be used for the following special characters: #, space, &, !,
:, ?, ., %, $, -, /, =, [, ], @, ^, (, ), _, +, {, }, |, ;, \, “ and ~.
14
iDCS_16sys_adm.qxd 12/14/2004 4:27 PM Page 19
15
PROGRAM TRUNK NAMES
This program is used to assign a character name or identification for each
C.O. line. You may assign a name of 11 characters long.
PROGRAM KEYS
UP & DOWN - Used to scroll and move cursor.
KEYPAD - Used to enter characters.
Hold - Press to clear entry.
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press Transfer and then dial 404 [7
01] TRUNK NAME
Display shows
2. Dial trunk (e.g., 704) OR press UP or [704] TRUNK NAME
DOWN to select trunk and press the right
soft key to move the cursor
3. Enter the trunk name using the procedure [704] TRUNK NAME
in Program Station Names and press the S
AMSUNG
right soft key to return to step 2
4. Press Transfer to store and exit programming
OR press Speaker to store and advance to
the next program
iDCS_16sys_adm.qxd 12/14/2004 4:27 PM Page 20
To Next Page
Loading...
