LED R&D Lab(VD)
100
2. IER Landscape Installation + IER-F Extension
• For installation of IER-F, use 1 x 1 Frame (VG-LFR11SWL) and use the JIG hole gap different from that of IER. (IER: 270 mm / IER-F: 240 mm)
• As in the following figure, use the JIG F (NEW) for ①, ③, and ④ and use the previous JIG (included in VG-LFR84FWL, VG-LFR53FWL, and
VG-LFR52SWL) for ②.
• For installation of ②, it is required to move the Stud of JIG (see page 9).
Fig1. IER-F Extension for General Installation of IER
IERIER
IER
IER-F
IER-F
IER-F
Existing JIG (VG-LFR84FWL, VG-LFR53FWL VG-LFR52SWL)
②
JIG F: ①,③,④
①
②
③
④
To Next Page
Loading...
