Need help?Do you have a question about the Samsung IAB Series and is the answer not in the manual?
Details on model specifications, appearance, and cabinet dimensions for IAB series.
Guidelines to prevent LED damage from impact, static electricity, and metal contact.
Recommendations for heat dissipation, room temperature, and air conditioning effects.
Guidelines for vertical wall and landfill installations, including gap requirements.
Information on required setup tools and available cabinet accessories.
Steps for unpacking and preparing the cabinet before installation.
List of wall mount parts and their quantities for different screen sizes.
Standard conditions for wall installation and screw fixing precautions.
Steps for installing the wall mount, connecting cables, and managing cabinet gaps.
Connecting various cables and checking the operation after P-FRONT installation.
Procedures for controlling Z seams, gaps, and adjusting SET tilt.
Instructions for installing side, top, and bottom bezels, and references for gap management.
Definition, detailed description, and constraints for operating dehumidification mode.
Conditions requiring dehumidification during installation and product use.
Information on condensation causes and prevention methods to maintain product quality.
Details on system and TCON IP settings and factory mode configuration.
Instructions for accessing and setting IP addresses in factory mode.
Guidelines for returning to default shipment specifications via factory reset.
Procedure for disassembling the screen bezels and bracket support.
Steps for disassembling power, system, and speaker cables in the docking station.
Disassembly procedures for sub screen components like bridge boards and Tcon.
Step-by-step guide for disassembling and assembling LED modules.
Methods for controlling module steps and reassembling sub screens.
Sequence for reassembling the docking station components.
Procedures for attaching screens and controlling seams between sub screens.
Procedure for replacing TCON board and updating firmware with factory data.
Steps for replacing LED modules and updating pixel data on the TCON board.
Guide for installing two IAB sets side-by-side and connecting video sources.
Settings for Video Wall mode and Picture Mode calibration.
Supported models and preparation materials for gradation calibration.
Instructions for mobile solution setup, IP address configuration, and precautions.
Steps for manual adjustment, selecting references, and completing calibration.
Supported timing resolutions for Framelock and Video Wall modes.
To Next Page
General