158
LED R&D Lab(VD)
SMC 사용법
1. Enter the IP of the IAB.
2. CONNECT click
3. If connected normally, it is changed to CONNECT →
CONNECTED and the layout information is displayed.
※ If it is not connected normally, the ‘Network
Connection Fail’ phrase appears. In this case, check IP
setting again.
※ If you connect to IAB using LAN cable rather than
WIFI, IP setting of mobile phone is required.
①
[Calibration procedure]
Enter the IP → Click ‘Connected’ button → Ref & Target setting → Click ‘Next’ button
→ Screen switching → Camera screen target positioning → Click ‘Adjust’ button → Measurement complete
Check if it is set to Select ‘SubModuleCal’
②
③
Gradation Calibration - SMC
To Next Page
Loading...
