159
LED R&D Lab(VD)
SMC 사용법
4. On the layout screen on the right, if you select a
cabinet to specify as Reference, the cabinet will be
displayed on the right.
Specifies ref or target in the cabinet
(If the target is not specified, calibration is performed
for all modules except the reference.)
5. Click ‘NEXT’ button
①
Check if it is set to Select ‘SubModuleCal’
②
③
④
⑤
click
click
Gradation Calibration - SMC
[Calibration procedure]
Enter the IP → Click ‘Connected’ button → Ref & Target setting → Click ‘Next’ button
→ Screen switching → Camera screen target positioning → Click ‘Adjust’ button
→ Measurement complete
To Next Page
Loading...
