LED R&D Lab(VD)
7
precautions Image
[Caution of LED damage caused by liquid]
When water or various chemicals touch the LED, the inside of the LED may be damaged.
① Water, dew, air conditioner condensate, sprayer, sweat, and saliva do not directly touch the
product.
- Be careful not to sweat on the product. (※ Maintain proper temperature so as not to sweat)
- Be careful not to spit on the product, and it is recommended to wear a mask.
② The following substances should not be directly in contact with the product, and
the case of exposure of the steam to the product should be minimized.
- Detergent or disinfectant : carpet cleaning detergent, glass cleaner, 84 disinfectant, etc.
(※ When cleaning the floor or wall with detergent or water, it is recommended to install a screen so that it does not touch the
product)
- Various chemicals: paints, mosquito repellents, cinnabar, benzene, toluene, solvents, surfactants, halogens (chlorine, bromine),
and substances containing these ingredients;
③ If liquid touches the product
- If there is water on the product, turn off the product immediately, dry it enough for more than a day, and run the
dehumidification mode to remove moisture from the LED. (※ P74, refer to "Dehumidification mode using LSM")
- If there is any liquid other than water on it, remove it with alcohol and run the dehumidification mode.
[Precautions related to construction]
① In the case of installation at the construction site, the product must be installed after construction and
cleaning are completed
.
② If the product is under construction in the installed space, take the following measures.
- Shielding film should be installed to protect the product by sealing the entire product so that it is not exposed to dust and
various liquids.
- Operates a video or 100 gray scale white for more than 2 hours every day.
- After the construction is completed, remove enough dust, various liquids, and steam, remove the shield, and execute the
dehumidification mode.
카펫
클리너
유리
세정제
Taping Shielding film
84
Disinfectant
※ Only use for IWA
◆ Installation precautions (LED damage)
1. Product and installation information
To Next Page
Loading...
