Need help?Do you have a question about the Samsung IER Series and is the answer not in the manual?
Overview of available LED display models and their series.
Detailed technical specifications for IER/IFR and IER-F/IFR-F series.
Guidelines to prevent LED module damage during installation.
Requirements for indoor installation, HVAC, and fan flow rates.
Minimum spacing for wall and recessed mounting installations.
Required tools and preparation steps before cabinet installation.
List of common and series-specific accessories for IER/IFR.
Steps for safely unpacking cabinets and verifying contents.
Process for checking screen functionality and appearance.
Attaching PET sheet and PCB covers to edge cabinets.
Checking all components included in the frame kit package.
Steps for installing the bracket side components.
Guidelines and precautions for tightening screws during installation.
Installing bracket middle and aligning cabinets for proper fit.
Adjusting the frame center for optimal alignment and gap control.
Adjusting frame flatness and performing vertical extensions.
Attaching the I/G to the rear of each cabinet.
Steps for installing cabinets in a PIVOT configuration.
Guidelines for installing recessed LED screens with minimal workspace.
Safety and operational precautions for installing S-Boxes.
Connecting visual signals, LAN, and OCM cables to the S-Box.
Initial picture quality settings and panel configuration for S-Box.
Guidelines for using the S-Box service port for monitoring.
Introduction to the LSM software for remote control.
Setting network IP information for the S-Box via USB or tool.
Adding new connections and configuring S-Box models in LSM.
Overview of the LSM home window and its functionalities.
Maximum connection limits and power consumption guidelines.
Precautions during cabinet installation and cable connection.
Guidelines for cabinet installation direction and cable connection.
Procedures for checking and adjusting seams and height differences.
Steps for disassembling and reassembling LED modules.
Components of the Frame Kit and cabinet product information.
Checking items in each frame kit package and JIG configuration.
Installation procedures for IER and IER-F extensions.
Installation procedures for PIVOT extensions of IER and IER-F.
Steps for fastening Cover PCBs on IER/IER-F cabinets.
To Next Page
General