LED R&D Lab(VD)
40
5. Cabinet + Frame Installation
◆ PIVOT installation
Fig1. Positions of BOLT ETCs fastened in delivered product
Fig2. Positions to fasten BOLT ETCs when installing the PIVOT
When installing the PIVOT, use the PIVOT-specific Frame Kit.
(VG-LFR51PWL / the same installation steps apply)
① Check that the BOLT ETCs are fastened. (Fig.1)
② Fasten the BOLT ETCs again appropriately for PIVOT installation. Fasten
two additional bolts and remove the COVER HANDLEs. (Fig.2)
③ Install with the arrow pointing up, by referring to the engraving indicating
the direction.
Engraving indicating
the PIVOT direction
Remove the COVER HANDLEs
To Next Page
Loading...
